Use Of Buttons; Automatic Lighting Connections - Sym MIO Anleitung

7.Use of Each Component

USE OF BUTTONS

Turn signal switch
Horn button

Electrical starter button：
This is a starting motor button (switch) for engine starting.
With the main switch "ON" position, press this button while holding the front or rear brake lever
will start the engine.
CAUTION:

Let go this button immediately after engine has been running, and never press the button again to
avoid damaging the engine.

This mechanism is a safety design. The engine can only be started after the front or rear brake
lever has been applied.
 Automatic Lighting Connections
Turn main switch to "ON" , at the same time, the electrical connections of lights will be connected
automatically, including LED daytime running lamps 、low beam headlight(s)、rear position lamp and
rear-registration plate illuminating cannot be switched ON or OFF otherwise than simultaneously.
CAUTION:
Automatic Lighting Connections are powered by battery, and therefore be aware of keeping main

switch on "ON" will run out of the battery without running the engine.

Turn Signal Switch：
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to "
lights will flash.
To release, simply return the turn signal light button to the original position.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.

Horn Switch：
Press this button, when ignition switch is in the "
CAUTION：
Do not press this button when you are in the area where there's no honking.
Return switch
", and slide the turn signal switch to left or right. Then, the turn signal
ON
" position, the horn will sound.
ON
10
Electrical
starter button