Attaching The Belt Clip; Placing The Handset In The Base/Charger - Siemens Gigaset S400 professional Bedienungsanleitung

Gigaset S790 / BRD-SEN EN / A31003-G2100-U112-3-7419 / starting.fm / 06.07.2011
First steps
12
¤
Insert the plastic cover provided for the
headset socket to ensure optimum sound in
speaker mode.

Attaching the belt clip

The handset has notches on each side to attach the belt clip.
¤
To attach – press the belt clip
onto the back of the handset so
that the protrusions on the belt
clip engage with the notches.
¤
To remove – press the centre of
the belt clip firmly with your right
thumb, push the fingernail of
your left index finger up between
the clip and the housing and pull
the clip in an upward direction.
Placing the handset in the
base/charger
¤
Place the handset in the base/charger with its display facing forward.
Each handset is registered with the base at the factory. You do not need to register
the handset again. If you wish to use your handset with a different base or use fur-
ther handsets with your base, you have to register the handset manually
¢
( page 40).
To charge the batteries, leave the handset in the base/charger.
Please note
Only place the handset in the designated base/charger.