Setting The Alarm Clock; Using Multiple Handsets; Registering Handsets - Siemens Gigaset S400 professional Bedienungsanleitung

Gigaset S790 / BRD-SEN EN / A31003-G2100-U112-3-7419 / registr_sett.fm / 06.07.2011

Setting the alarm clock

Setting the alarm clock
Prerequisite: The date and time have
already been set (
Activating/deactivating and
setting the alarm clock
á
¢
v
¤
You can enter data in the following fields:
Activation:
Select On or Off.
Time:
Enter the wake-up time in 4-digit format.
How often:
Daily
Select
Volume:
Set the volume (1–6).
Melody:
Select melody.
§Save§
In idle status, the
are displayed.
A wake-up call is signalled on the display
and with the selected ringtone (
The wake-up call sounds for 60 seconds. If
no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
While the wake-up call sounds, you can
permanently change the volume by press-
ing the side keys ø (louder) or ÷ (quieter).
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite: A wake-up call is sounding.
§OFF§
or
§Snooze§
40
¢
page 14).
¢
Alarm Clock
or Monday-Friday.
Press the display key.
¼
icon and wake-up time
¢
Press the display key. The wake-
up call is deactivated.
Press the display key or any key.
The wake-up call is deactivated

Using multiple handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset S4 professional handset can be
registered on up to four bases.
Manually registering a
Gigaset S4 professional an
Gigaset S400 professional
You must activate manual registration of the
handset on both the handset and the base.
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
shown in the display e.g., INT 1. If not, repeat
the procedure.
page 3).
On the handset
The handset is not registered to a base.
§Register§
The handset is already registered to a base:
Ï
¢
v
¢
Register Handset
If the handset is already registered to four
bases:
s
~
A message appears stating that the handset
is searching for a base that is ready for regis-
tration.
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
completely.
Press the display key.
¢
Registration
Select base, e.g., Base 3 and
§OK§
press .
If required, enter the system PIN
for the base and press
§OK§
.