Setting Keypad Illumination; Activating/Deactivating Auto Answer; Changing The Speaker/Earpiece Volume; Setting A Handsfree Profile - Siemens Gigaset S400 professional Bedienungsanleitung

Gigaset S790 / BRD-SEN EN / A31003-G2100-U112-3-7419 / registr_sett.fm / 06.07.2011
Handset settings
¤
You can enter data in the following fields:
In Charger
Select On or Off.
Out of Charger
Select On or Off.
Please note
With the On setting, the standby time
of the handset can be significantly
reduced.
§Save§

Setting keypad illumination

The brightness of the keypad illumination
can be set to one of five levels.
Ï
¢
v
¢
Keypad Illumination
The current setting is displayed.
¤
You can enter data in the following fields:
Brightness:
Select 1 (darkest) to 5 (brightest).
§Save§
•
Activating/deactivating
auto answer
If you activate this function, when you
receive a call you can simply lift the handset
out of the base/charger without having to
press the talk key c.
Ï
¢
v
§Change§
48
Press the display key.
¢
Display + Keypad
Press the display key.
¢ ¢
Telephony Auto Answer
Press display key (³= on).
Changing the speaker/
earpiece volume
You can set the loudspeaker volume for
speaker mode and the earpiece volume to
five different levels.
During a conversation via the earpiece or in
speaker mode:
ø/ ÷
Press the side key to call up the
Handset Volume menu.
Change the volume by pressing
ø (louder) or ÷ (quieter).
or
t
Press the control key to call up
the Handset Volume menu. Set
the earpiece or speaker volume
by pressing r.
The setting will automatically be saved after
approximately 3 seconds, if not then press
§Save§
the display key .
If t is assigned to another function:
§Options§
Open menu.
Volume Select and press
Configure setting (see above).
Please note
u
The settings for the earpiece also
apply to a connected headset.
u
You can also set the call volume using
¢
the menu ( page 25).

Setting a handsfree profile

In idle state, you can set various handsfree
profiles to optimally adapt your phone to
your environment.
Profile 1
The optimum setting for most connec-
tions and set as default.
Profile 2
Optimum volume in handsfree mode.
However, this means that the participants
cannot speak at the same time as the per-
son speaking is given preferential trans-
§OK§
.