On-Screen Display - Sony BRAVIA VPL-HW15 Handbuch

Symptom
The picture is too dark.
The picture is not clear.
The picture flickers.
The color of characters or
the picture is not
appropriate.

On-screen display

Symptom
On-screen display does not
appear.
The model name does not
disappear from the screen.
Input terminals do not
appear.
Remote control
Symptom
The remote control does
not work.
Cause and Remedy
c Adjust the "Contrast" or "Brightness" of the Picture
properly. (1 page 44)
c Adjust the focus. (1 page 20)
c Condensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
c For pictures from a computer, activate "APA" and adjust the
current input signal.
c Adjust "Phase" for "Adjust Signal" in the Screen
properly. (1 page 49)
c Select the desired color registration in "Panel Alignment" of
Installation menu (1 page 55).
Cause and Remedy
c Set "Status" in the Setup
c Check if the ON/STANDBY indicator should light in green.
c The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
c Set "Auto Input Search" in the Function
page 53)
Cause and Remedy
c Batteries could be weak. Replace them with new batteries.
(1 page 10)
c Insert the batteries with the correct polarities. (1 page 10)
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
c Confirm the position of the remote control detector on the
projector. (1 page 7)
menu to "On." (1 page 50)
menu to "Off". (1
menu
menu
61