Operation; Installing The Water Filter - Sage Precision Brewer BDC400 Kurzanleitung

Operation

WATER HARDNESS SETTING
& FLUSHING
1. Ensure that the empty coffee basket and empty
carafe (with lid attached) are inserted into
the machine.
2. Fill the water tank with fresh cold water to
the MAX mark on the water tank. Plug into
power outlet.
3. When first turned on, the machine will show
'SEt HArdnESS' on LCD, asking you water
hardness level. Press SELECT dial once. Dip
the water hardness test strip into the filled water
tank for 1 second. Remove and wait 1 minute to
reveal the result.
4. Rotate SELECT dial until the corresponding
test result is shown on the screen. Press to set.
5. Install the water filter into the water tank before
continuing to the flush cycle.
6. The machine will show 'FLUSH Unit' on LCD.
Press SELECT dial to commence flush cycle.
The machine will dispense all the water from
the tank, through the system and into the empty
carafe. After flushing, empty the basket and
carafe.
8

INSTALLING THE WATER FILTER

This product is designed to be used with a water
filter installed in the water tank. Not doing so will
affect the internal components and performance of
the appliance.
The filter cartridges should be replaced regularly;
when indicated on the LCD screen.
NOTE
All water tank levels will be incorrect if the machine
is used without the water filter correctly installed.
1. Remove the water filter and water filter adapter
from the packaging.
2. Soak the filter in cold water for 5 minutes.
3. Attach water filter to adapter.
4. Insert the assembled water filter and adapter
into the water tank.
5. Fill the water tank with cold water to the
indicated MAX marking.