Cleaning And Maintenance - inshape 17401 Gebrauchsanweisung

The computer's buttons
Button
Incline +/-
Mode/
Reset
Select
GB
Speed +/-
Start
Stop
Volume +/- Adjusts the volume of the
4/6/8/
10/12/14
18
38
Function
Sets the treadmill's incline
from 0-15%
Changes between the P1-P9
autoprograms and resets
the training parameter
values for countdown
Changes between the
training parameters
(training time, distance and
calorie consumption)
Increases/reduces the speed
of the belt 1 km/h at a time
Hold the button pressed to
change the speed rapidly.
Starts the belt, starts the
training session
Stops the belt, stops the
training session
connected MP3 player
Adjusts the belt speed to 4,
6, 8, 10, 12 or 14 km/h
This button can be found on
the left handle and adjusts
the speed of the belt to 18
km/h.
Setting before exercising
Press the Select button to select training
parameters. You can set the training time,
distance or calorie consumption by pressing
the Speed+/- buttons.
Press the Start button to start exercising.
Adjust the speed by pressing the Speed +/-
buttons or 4/6/8/10/12/14/18.
Adjust the incline by pressing the Incline
+/- buttons.
When the set parameter is reached, the
treadmill automatically stops.
Training with an autoprogram
Press the Mode/Reset button to select an
autoprogram from P1 to P9 (see the table at
the back of this instruction manual).
The training time is 16 minutes, which
consists of 16 1-minute levels.
Press the Start button to start exercising.
The belt starts after 3 seconds
It is not possible to change the speed
manually during the training session,
as this is controlled by the computer's
autoprogram.
When the set time has passed, the treadmill
automatically stops.

Cleaning and maintenance

Wipe the treadmill down regularly with a
well-wrung cloth.
Unplug the treadmill. Open the motor cover
and remove any dust from the motor and
sensor.
Check the condition of the treadmill
regularly and tighten any bolts, screws and
nuts as necessary.