Daily Maintenance; Assembly Instruction - inshape 17168 Gebrauchsanweisung

Daily maintenance

1. Warning: cut power off and make sure
there is no water percolation before daily
cleanning and maintance for Mini Walk.
2. Clearance: comprehensive clean will
extend Mini Walk's life. Cleaning dust
regularly. Make sure the exposed parts of
running belt must be cleaned. Wearing
clean sport shoes to avoid any dust and
impurity into running belt and running
board. Use wet rag with soap to clean the
running belt. Pls attention that do not
use too much water and avoid leakage to
the inner electrical parts.
3. Warning: Cut off the power before
disassemble the motor cover.
4. Disconnect the plug when Mini Walk
won't be used for a long time.
5. Do not store it in bathroom and out door
place.
6. In order to prolong Mini Walk's life, do
not use Mini Walk more than 1 hour at
one time.

Assembly instruction

Mini Walk is completely assembled. Plug
in and start to use directly. Assemble
instruction for users who buy handrail
seperately only
Assemble instruction for handrail:
1. Put Mini Walk face down, make sure there
are no sharp items and no impurity on
the fl oor to avoid scraches of the surface
of Mini Walk .
2. Put handrail face down, overlap both
sides of Mini Walk . Make sure the holes
are aligned.
3. Locking un-support parts in both sides
with screws. 8 screws in total.
4. Locking support parts in both sides with
screws, set it up.
5. Overlap the holes of long support
part (the part which stretch across the
running belt), then lock the screws in the
fi rst row and then lock the screws in the
last row. Finish assemble.
6. Put Mini Walk face up, plug in and start
to enjoy the Mini Walk.
GB
37