Jamara Major BL RTR Gebrauchsanleitung Seite 23

6. Max. Reverse: This option is used to adjust the top speed
when driving in reverse
7. Brake Force Min.: The effect that the brake has when first
applied can be set here. The default setting will be whatever
has been set in the option 'Brake Max' (see option 2).
8. Neutral Zone: The 'neutral Zone', which is the area between
forwards and reverse or braking can be set to 'Narrow',
'Normal' or 'Wide' as shown in the illustration below. This
Zone can be set for both 'stick' or 'pistol-grip' type
transmitters as shown.
Max. Forwards
Forwards zone
Brake and reverse zone
Max. Braking effect
Max.
Neutral zone
Forwards
Neutral point
Forwards
zone
9. Timing: It is important that the correct timing is selected for
a Brushless motor and you can set the timing here. Please
refer to you motor's instructions for the correct setting. As a
rule of thumb, raising the timing will increase the output of
your motor but at the cost of a higher current draw.
10. Motor Type: This ESC has been exclusively designed for use
with Brushless motors and so you cannot make any changes
here.
11. Temp. Cut-Off: The ESC is equipped with an accurate
temperature sensor which will switch the unit off if a
temperature of 95°C is exceeded for 5 seconds or more. This
situation will be indicated by a flashing green LED.
function can be switched off, for example whilst racing, but
extreme care must be taken that the unit is adequately cooled.
The default setting can be restored by pressing the 'SET'
button for 3 seconds when the throttle control is in the
neutral position. The red and green LED's will then flash
simultaneously to indicate that the factory setting has been
restored.
Neutral zone
Neutral point
Max. Braking effect
Brake and reverse zone
8. 12 V Cooler
To optimise the ESC's performance the heat sink has been fitted
with a cooling fan. This will ensure maximum power output and a
stable BEC voltage. The cooling fan is clipped onto the heat sink
and will create an optimal air flow to dissipate the heat as shown
below, the air will follow the direction of the arrows.
Fan
Warning:
The cooling fan may only be driven by a 2 cell LiPo or 4 - 6 cell
NiMH battery pack. The use of a higher voltage packs will damage
the fan.
This
Heat sink
ESC
23