Solamagic S1 Montage- Und Gebrauchsanleitung Seite 132

Step 3: Installing the blind frame
Warning: Risk of injury!
Always wear safety gloves!
• Apply pressure to the springs, until they engage in the retainer.

Warning: Risk of crushing due to springs jumping back. Do not reach into
the clamping area of the springs!
• Fit an unlocking device at the kink in each spring and allow to hang out of the

frame cut-out.

• Positioning the frame: Position the pre-tensioned spring tips in the gap of the

heater cover.
• Press the blind frame against the cut-out in the ceiling

• Pull the unlocking devices down and allow each of the springs to snap against

the mounting frame.
Note: Store the unlocking devices carefully somewhere for subsequent
removal and re-installation.
Removal:
• Pull the blind frame at the outer edge from the ceiling until the clamping springs
can be reached in the gap.
Warning: Risk of injury!
Always wear safety gloves!
• Press the springs back and swivel the frame out of the installation space. Slow-
ly release the springs.
06/2019


132