Solamagic S1 Montage- Und Gebrauchsanleitung Seite 127

2b. Installation, radiant heater S3 and D3
with T-brackets
Heater type Power
IR 05008 2500 W
DS 05002 2000 W
DS 05006 2000 W
Step 1: Installing the T-brackts
• Install the S3 or D3 radiant heater using 2 T brackets at a separation of
400 mm while observing the safety distances and safety instructions (see Ap-
pendix 2).
• Secure the T-bracket (1) with the silicone plate (2) below it on the fastening sur-
face with 2 screws each according to the following figure. When wall-mounted the
heater swivels to the horizontal, lower longitudinal hole side of the T-bracket (1).
When mounting on the ceiling/roof, the swivel range must be aligned for opti-
mum heating effect towards the opposing longitudinal hole side (in contrast to
the image below, swivel range 30°). If necessary, the adapter claw should be
unscrewed from the bracket and turned through 180° before screwing back on
to the bracket.
Step 2: Installing adapter claws on the T-brackets
• Fit adapter claws (6) at both of the T-brackets installed on the mounting sur-
face, fit safety washer (12) between the T-bracket and adapter claw and screw
in hex socket head screws (11) from outside into the T-bracket.
Wall installation
Horizontal Vertical



127
Ceiling installation
Horizontal Inclined



06/2019