Solamagic S1 Montage- Und Gebrauchsanleitung Seite 126

Step 3: Installing the heater on the wall mounting
• Push the securing lugs (3) with the ring (4) from the left side into the dovetail
groove for approx. 170 mm
• Tighten the 3.5 x 6.5 screw (5).
• Turn the eccentric tensioner (7) of the adapter claw (6) to the left as far as it will
go (see figure below, coding pin points towards the SOLAMAGIC lettering (C)).
• Attach heater (B) at the top in the hammer groove side on the adapter claw (6)
and swing in at the bottom on the eccentric tensioner side (7).
Warning: The adapter claw must now engage in each of the two device
grooves (visual check)
• Tighten the eccentric tensioner (7) by turning the supplied 5 mm hex-key in
a clockwise direction (approx. 80° angle of turn). The heater must be tightly
connected to the adapter claw so that it is free from play.
Attention: there is no rotation-stop; do not turn through 180° – do not
over-turn the eccentric spanner!
• Fit the retaining ring (4) in the cut-out (A) of the adapter claw (6).
• To set or adjust the direction of radiation, use a 5 mm Allen key to loosen the
screws (11), shift the heater into the required direction and re-tighten the screws
(11).
06/2019
126