Solamagic S1 Montage- Und Gebrauchsanleitung Seite 130

Step 2: Preparing the installation space
• Create a ceiling cut-out with the dimensions 280 mm x 850 mm.
• Drill fastening holes in the ceiling panel.
Step 3: Mounting the heater in the installation space
• Connect the device to the electricity, but do not switch on.
• Position the device in the ceiling cut-out.
Warning:
The connecting cable must be led away directly from the device. It must be
routed in the installation space away from the cut-out area.
• From the outside screw the installation frame to the ceiling panel using six 4 mm
diameter screws.
Warning:
Ensure the screw joint is secure and permanent.
If necessary, use additional mounting frames (accessories)!
06/2019
130