Solamagic S1 Montage- Und Gebrauchsanleitung Seite 125

2a. Installation, radiant heater S1 with T-bracket
Heater type Power
IR 05001 1400 W
IR 05002 2000 W
Only approved for wall mounting!
Step 1: Installing the T-brackts
• Secure the T-bracket (1) with the silicone plate (2) below it on the fastening
surface with 2 screws each according to the following figure.
Step 2: Installing adapter claws on the T-bracket
• Push the adapter claw (6) into the T-bracket (1) mounted on the fastening sur-
face. Insert the M8x20/5 mm AF screw (8) into the hole. Insert washer (9) and
tighten M8/13 mm AF nut (10).
• If the adapter claw (6) cannot be aligned facing downwards, screws (8) to (10)
must be undone and the claw pulled out from the bracket. Then remove screws
(11) and refit the middle part (13) with the cloth disc (12) rotated through 180°
on the adapter claw (6). Then refit the device at the wall bracket.
Wall installation
Horizontal Vertical
 
 
125
Ceiling installation
Horizontal
Inclined
06/2019