Installation Instructions - Solamagic S1 Montage- Und Gebrauchsanleitung

Installation instructions

• The radiator must only be installed using suitable fastenings (e.g. use M6x60
bolts with steel anchors in a stone or concrete substrate) on firm, load-bearing,
normally combustible, flame-resistant or non-combustible substrate.
• If radiator and socket are not installed on the same surface, it must be ensured
that the field of radiation cannot be directed towards the socket. Failing this,
it must be ensured that the socket cannot heat up to more than 70°C during
heater operation.
• The safety distances given in Appendix 2 must be observed.
• The area in which the heat acts can be estimated from the radiation diagram
(Appendix 3). The diagram shows the sizes of the irradiated areas at various
distances from the radiant heater and in each case the maximum radiation
intensity.
• Installation height: at least 1.80 m above the ground
• The radiator must be installed with the hammer groove upwards. The hammer
groove can be seen when looking at the housing side with the power lead (see
figure below).
• The S3 und D3 (IR 05008, IR 05028, DS 05002, DS 05006, DS 05028) radia-
tors must be fitted and operated in a horizontal position.
• Only for types IR 05001 and IR 05002: If mounted on a sloping ceiling or verti-
cal wall, the heater must be fitted with the power lead assembly facing „down".
During mounting
always up
During mounting
always down
123
06/2019