Technical Data; Installation - Zanussi ZFU20200WA Benutzerinformation

Problem
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
www.zanussi.com
Possible cause
The temperature regulator is not
set correctly.
Height
Width
Depth
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1540 mm
595 mm
658 mm
20 h
230 - 240 V
50 Hz
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circu-
late freely around the back of the cabinet. To
ensure best performance, if the appliance is
positioned below an overhanging wall unit, the
minimum distance between the top of the cab-
inet and the wall unit must be at least 100
mm . Ideally, however, the appliance should
not be positioned below overhanging wall
units. Accurate levelling is ensured by one or
more adjustable feet at the base of the cabi-
net.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be
easily accessible after installation.
Solution
9