Technical Data; Installation - Zanussi ZFU428MW Benutzerinformation

Problem
The temperature in the
freezer is too high.
There is too much frost.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
www.zanussi.com
Possible cause
The Fast Freeze function is switch-
ed on.
The temperature regulator is not set
correctly.
Many products are stored at the
same time.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Refer to" Fast Freeze function".
Set a lower temperature.
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1850 mm
600 mm
660 mm
18 h
230 - 240 V
50 Hz
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Solution
21