Technical Data - Zanussi ZFC321WA Benutzerinformation

4. When defrosting is completed, dry the interior thor-
oughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain the maxi-
mum coldness and run the appliance for two or
three hours using this setting.
7. Reload the previously removed food into the com-
partment.

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the rating plate
on the external right side of the appliance and in the en-
ergy label.
Installation
Positioning
This appliance can be installed in a dry, well ventilated
indoor (garage or cellar), but for optimum performance
install the appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on
the rating plate of the appliance:
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Ventilation requirements
1. Put the freezer in horizontal position on a firm sur-
face. The cabinet must be on all four feet.
20
Height
Width
Depth
Ambient temperature
Important! Never use sharp metal tools to scrape off
frost as you could damage the appliance. Do not use a
mechanical device or any artificial means to speed up
the thawing process other than those recommended by
the manufacturer. A temperature rise of the frozen food
packs, during defrosting, may shorten their safe storage
life.
ZFC321WA
868 mm 876 mm
806 mm 1061 mm
665 mm 665 mm
28 h 32 h
2. Make sure that the clearance between the appliance
and rear wall is 5 cm.
3. Make sure that the clearance between the appliance
and the sides is 5 cm.
The airflow behind the appliance must be sufficient.
Electrical connection
Before plugging in, ensure that the voltage and frequen-
cy shown on the rating plate correspond to your domes-
tic power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect
the appliance to a separate earth in compliance with cur-
rent regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
ZFC330WA ZFC340WA
876 mm
1336 mm
665 mm
31 h