Technical Data; Installation - Zanussi ZFU319EW Benutzerinformation

Problem
The appliance does not cool at all Plug is not connected to the mains
Green indicator flashing
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".

Technical data

Dimension
Rising Time
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
20
Downloaded from Fridge-Manual.com Manuals
Possible cause
socket properly
There is no voltage in the mains socket
(try to connect another appliance into
it)
The appliance is not switched on
Temperature Regulator is not on
Temperature sensor problem
Height
Width
Depth
Connect the mains plug properly
Call an electrician
Switch on the appliance
Check the Temperature Regulator
Call the service personnel
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
1250 mm
545 mm
640 mm
18 h
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
Solution
Ambient temperature