Technical Data; Installation - Zanussi ZFX405W Benutzerinformation

Problem
It is too cold inside the
freezer
The appliance does not
work at all.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
www.zanussi.com
Downloaded from www.Manualslib.com
Food placed in the appliance was
too warm
Products to be frozen are placed
too closely to each other
Temperature regulator may be set
incorrectly
Plug is not connected to the mains
socket properly
Power does not reach the appli-
ance
The appliance is not switched on
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Plug is not connected to the mains
socket properly
Height
Width
Depth
manuals search engine
Possible cause
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a
location where the ambient temperature corre-
Solution
Allow food to cool to room tempera-
ture before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical de-
vice to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
520 mm
525 mm
587 mm
17 h
230 V
50 Hz
29