Technical Data; Installation - Zanussi ZFU719EW Benutzerinformation

3. If necessary, replace the defective door
gaskets. Contact the Service Center.

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a
location where the ambient temperature corre-
sponds to the climate class indicated on the
rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
34
Height
Width
Depth
1. Fit the spacers
2. Turn counter-
Levelling
When placing the ap-
pliance ensure that it
stands level. This can
be achieved by two
adjustable feet at the
bottom in front (2). If
necessary adjust the
feet by removing the
spacer (1).
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz
into the holes.
Make sure that
the arrow (A) is
positioned as
shown in the pic-
ture.
clockwise the
spacers through
45° until they
lock into place.
A
45˚
1
2
www.zanussi.com