Technical Data; Installation - Zanussi ZFU20200WA Benutzerinformation

Problem
The temperature in the
freezer is too low.
The temperature in the
freezer is too high.
There is too much frost.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
www.zanussi.com
Possible cause
The product temperature is too
high.
The room temperature is too high.
The temperature regulator is not set
correctly.
The Fast Freeze function is switch-
ed on.
The temperature regulator is not set
correctly.
Many products are stored at the
same time.
Products are too near to each other. Store products so that there is cold
Food is not wrapped correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
Set a higher temperature.
Refer to" Fast Freeze function".
Set a lower temperature.
Store less products at the same time.
air circulation.
Wrap the food correctly.
Set a higher temperature.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1540 mm
595 mm
658 mm
20 h
230 - 240 V
50 Hz
Positioning
Install this appliance at a location where the am-
bient temperature corresponds to the climate
Solution
9