Inhaltsverzeichnis
Werbung
Installing the CPX2000 Series System and Field Replaceable Units
!
Warning
3
3-52
System may have multiple power supply cords. Disconnect all
power supply cords before servicing.
2. Set the power supply switch(es) to OFF (O) where necessary.
3. Insert a flat head screwdriver into the fuse cap. Refer to the figure
on page 3-40 for the location of the fuse cap.
4. While pushing in, turn the fuse cap 1/4 turn, counterclockwise until
the cap loosens.
5. Remove pressure and the cap pops part way out.
6. Pull the fuse cap and fuse the rest of the way out of the fuse
assembly.
7. Check the fuse and, if necessary, replace with a 250V, 8A fuse.
Literature Center Web Site
Werbung
Inhaltsverzeichnis
