Inhaltsverzeichnis
Werbung
Note
3. Verify that the AC 115/230 Voltage Selector Switch is in the same
4. Insert the second power supply and make sure it is seated firmly.
5. Install the three mounting screws. Do not tighten until all mounting
6. Install the AC power cord.
7. Turn on the second power supply.
8. Verify that the LED on the second power supply comes on.
Removing and Replacing AC/DC Power Supplies in the CPX2408 System
This section tells you how to remove/install an AC/DC power supply in the
CPX2408 system. If you need information about removing/installing an
AC power supply, refer to the section titled, "Removing and Replacing AC
Power Supplies in the CPX2408 System."
1. To remove a filler panel or AC/DC power supply, remove the
http://www.motorola.com/computer/literature
Middle mounting screws interfere with installation of the
power supply if not removed.
position as the existing power supply.
screws are in place.
mounting screws.
Removing and Installing the Power Supplies
3
3-45
Werbung
Inhaltsverzeichnis
