Removing And Installing The Cpu Transition Module; Tools You Need; Removing The Cpu Transition Module - Motorola CompactPCI CPX2000-Serie Installationsanleitung

Removing and Installing the CPU Transition
Module
This section tells you how to remove and replace a transition module. The
transition module mounts at the rear of the chassis.

Tools You Need

You need a number 1, Phillips head screwdriver, with a four inch shaft.

Removing the CPU Transition Module

Use this procedure to remove the CPU Transition Module from the chassis.
Set the main power switch on the front of the chassis to OFF
!
(O). Set the power supply switch(es) to OFF (O)
(CPX2208DC and CPX2408 only).
Caution
1. Set the main power switch to OFF (O).
2. Set the power supply switch(es) to OFF (O) (CPX2208DC and
3. Disconnect the power cord(s) from the source to make sure that you
System may have multiple power supply cords. Disconnect all
!
power supply cords before servicing.
Warning
4. Remove the six screws from the rear panel covering the transition
5. Remove the panel (CPX2108 only).
http://www.motorola.com/computer/literature

Removing and Installing the CPU Transition Module

CPX2408 only).
remove power from the system.
module cage (CPX2108 only).
3
3-19