Inhaltsverzeichnis
Werbung
4. Install the mounting screws. Do not tighten until all mounting
5. Install the power cord.
6. Turn on the second power supply.
7. Verify that the power-on LED on the second supply comes on.
Additional IDE Devices on Your CPX2000
System
CPX2108SK1 systems ship from the factory set as Configuration 2 in
Table
from the factory set as Configuration 13 in
3-6
for other possible configurations for IDE devices.
Note
Configuration 2
Configuration 13
http://www.motorola.com/computer/literature
Additional IDE Devices on Your CPX2000 System
screws are in place.
3-6. CPX2108SK2, CPX2208SK3 and CPX2208TSK2 systems ship
CPX2208SK2 systems are configured at the factory for use
with Small Computer System Interfaces (SCSI) only.
CPU hard drive master connected to the primary, Channel 1 located
on the CPU
CPU floppy drive connected to the floppy connector on the CPU
hard drive in a drive bay, set as Master only, connected to the
primary, Channel 1 on the CPU Transition Module
CD-ROM master in a drive bay, connected to the secondary,
Channel 2 on the CPU Transition Module
floppy drive in a drive bay, connected to the floppy connector on the
CPU Transition Module
Table
3-6. Also refer to
3
Table
3-47
Werbung
Inhaltsverzeichnis
