Inhaltsverzeichnis
Werbung
4. Tighten the captive screws on the top and bottom of the panel.
Step 1
Removing and Installing "Hot Swap" I/O
Modules
This section tells you how to remove and install "hot swap" I/O modules.
Only properly trained service personnel should remove or
!
install "hot swap" I/O modules. Do not touch bare parts inside
the enclosure because of the possible presence of hazardous
Warning
energy levels.
You can remove "hot swap" I/O modules without removing power from
the system. Refer to Appendix D, "Related Documentation" for
information about the PCI Industrial Computer Manufacturer's Group
(PICMG) Hot Swap Specification.
http://www.motorola.com/computer/literature
Removing and Installing "Hot Swap" I/O Modules
Step 2
Step 3
3
Step 4
2245 9805 (i)
3-17
Werbung
Inhaltsverzeichnis
