Connecting The System - Motorola CompactPCI CPX2000-Serie Installationsanleitung

Installing the CPX2000 Series System and Field Replaceable Units

Connecting the System

3
!
Caution
3-8
Use this procedure to connect your system.
Before connecting the CPX2000 Series chassis to an AC/DC
source, verify that the DC source has reinforced insulation
acceptable to 250 Vrms. It should meet the requirements of
Telephone Network Voltage (TNV) or Safety Extra Low
Voltage (SELV) voltages, and the following safety agency
requirements:
IEC950/EN60950
UL 1950
CSA 950
Connecting to any other type of AC/DC source violates IEC,
UL, and CSA safety approvals.
To connect your system:
1. Make sure the ON/OFF power switch on the front of the chassis is
set to OFF (O).
2. Make sure the ON/OFF power switch on the front of the AC or DC
power supply is set to OFF (O) (CPX2208DC and CPX2408 only).
3. Plug the socket end of the chassis power cord(s) packed with your
system into the AC inlet on the rear of the chassis.
4. Connect three wires to the power input block on the front of the DC
power supply (CPX2208DC only).
If you are using a monitor continue to step 5. If not, skip to step 8.
5. Connect the socket end of the monitor's power cord into the
connector on the back of the monitor.
6. Connect one end of the monitor (video) cable into the port on the
monitor. (Not necessary if your monitor comes with the cable
attached.)
Literature Center Web Site