Inhaltsverzeichnis
Werbung
Removing and Installing the 3.5 Inch Floppy Drive, CD-ROM Drive or Hard Disk Drive
7. Slide the floppy drive, CD-ROM drive or hard disk drive out the
For the floppy drive and hard disk drive, use the following steps 8 through
12.
8. Remove the four screws (4-40) holding the two drive rails (one on
9. Remove the drive rails from the sides of the carrier.
10. Remove the four or six screws holding the drive in the carrier.
11. Remove the drive from the carrier
12. Reverse this procedure to install a drive back into the chassis.
For the CD-ROM drive, use the following steps 13 through 15:
http://www.motorola.com/computer/literature
front of the chassis.
Floppy Drive
each side) to the sides of the drive carrier.
Drive Rails
Drive Rail
Guides
2157 9804 (i)
3-33
3
Werbung
Inhaltsverzeichnis
