Adjusting The Paper Near-End Sensor - Citizen CBM1000 Bedienungsanleitung

4.5 Adjusting the Paper Near-end Sensor

1
Open the printer cover.
2
Push the sensor knob in the
direction of arrow 1 to disengage its
claw (Or unlock the sensor unit), and
then adjust the sensor unit to a
desired paper remaining position
within the range shown by arrow 2.
3
The following table shows the
relationship between adjustment
positions and levels of paper roll
remaining. (A rough guide)
Adjustment Level of paper remaining
position (Paper roll outside dia. mm)
1
2
3
4
* When specified paper rolls are used.
CAUTION:
Use the level of paper remaining (Paper-roll outside diameter) just as a guide as it varies
depending on the particular printer and paper rolls used.
φ 18
φ 21
φ 24
φ 27
— 15 —
Sensor knob
Arrow 1
Arrow 2
4 3 2 1
Adjustment
position
Sensor unit