Adjusting The Paper Near-End Sensor - Citizen CT-S601 II Benutzerhandbuch

3.1 0

Adjusting the Paper Near-end Sensor

Change the settings of the paper near-end sensor to set the position at which
the near-end of the paper is detected.
1. Use a pointed object, such as a pen, to gently press the button to change the pap er
near-end sensor.
2. Press and hold dow n the button whil e moving the pap er near-en d sensor up, down,
right and left. The sensor positions are shown below for the various diameters of the
paper roll used.
Senso r positi on
A, a
B , b
*
C
Note:
*: Position of sensor when shipped from factory. However, factory settings differ depending on the
destination market.
CAUTION
 The amount of paper remaining on the roll (diameter of the roll) depends on the type
of paper used.
 The paper roll diameters in the table are guidelines.
("A" and "B" are for horizontal installations, and "a" and "b" are for vertical or
wall installations.)
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Diame ter when detected as near end
31
23
Paper near-end sensor function is off
Button to change paper
near-end sensor
V10 CONSUMIBLES S.L.
Diameter of core of pape r roll used
— 35 —
(Unit: mm)
18
18