Slicing And Shredding - Vitek VT-1604 PR Betriebsanweisung

ENGLISH
• Before first use, thoroughly clean all
parts that will be in contact with food
products.
• Choose a flat surface and place the cup
(8) on the non slip stand (10).

SLICING AND SHREDDING

1. Place the attachment holder (11) onto
the rod (9) in the combine cup.
2. Choose the desired shredder (17 18) or
slicing blade (16).
3. Place the chosen blade into the opening
in the disk (15).
4. Place the disc (15) onto the attachment
holder (11).
5. Close the cup's lid (5) by aligning the
grooves on the lid (5) with the ledges on
the cup (8).
6. Sent the control knob (2) to the OFF
position.
7. Place the motor block (1) onto the cup
(8).
8. Insert the power plug into the electrical
outlet.
9. Place the control knob in the PULSE
position; the side locks (4) will attach
the motor block (1) to the cup (8).
10. Prepare the food that you wish to
shred or slice.
11. Using the control knob (2), set the
desired speed or use the PULSE button
(3) to set the maximum speed.
12. Insert the food into the loading bunker
(6) and, without applying much pres-
sure, push the food with the pusher (7).
Do not push food into the loading bun-
ker with your fingers or any other item
(e.g., spatula) while the device is oper-
ating. Only the supplied pusher may be
used for this purpose.
13. When you are finished using the device,
set the control knob (2) to the PULSE
position and remove the power plug
from the outlet.
14. Set the control knob (2) to the OFF
position and remove the motor block,
1604.indd 4 1604.indd 4
the lid (5), and the disc (15), and then
remove the shredded or sliced food
from the cup using the spatula (19).
CHOPPING FOOD
1. Place the attachment holder (11) onto
the rod (9) in the combine cup.
2. Remove the blade (12) from the protec-
tive case (13).
3. Place the blade (12) onto the holder
(11). Be careful, as the blades are very
sharp.
4. Place the food to be chopped into the
cup (8).
5. Close the cup's lid (5) by aligning the
grooves on the lid (5) with the ledges on
the cup (8).
6. Sent the control knob (2) to the OFF
position.
7. Place the motor block (1) onto the cup
(8).
8. Insert the power plug into the electrical
outlet.
9. Place the control knob in the PULSE
position; the side locks (4) will attach
the motor block (1) to the cup (8).
10.Place the pusher (7) into the loading
bunker (6) to prevent chopped food
from being thrown out of the cup.
11.Using the control knob (2), set the
desired speed or use the PULSE button
(3) to set the maximum speed.
12.When you are finished using the device,
set the control knob (2) to the PULSE
position and remove the power plug
from the outlet.
13.Set the control knob (2) to the OFF posi-
tion and remove the motor block, the
lid (5) and the attachment holder (11)
together with the blade (12).
14.Extract the chopped food from the cup
using the spatula (19).
ATTENTION!
Do not use the device for more than
10 seconds.
4 4
28.07.2008 14:21:23 28.07.2008 14:21:23