Safety Instructions - Vitek VT-1604 PR Betriebsanweisung

FOOD PROCESSOR
DEVICE DESCRIPTION
1. Motor block
2. Speed control knob, open/close side
locks
3. PULSE button
4. Side locks
5. Lid
5a. Sealing ring
6. Loading bunker
7. Pusher
8. Cup
9. Rod
10. Non slip support
11. Attachments holder
12. Chopping blade
13. Protective case for chopping blade
14. Attachment for mixing/beating
15. Disc for blade installation
16. Slicing blade
17. Thin shredding blade
18. Thick shredding blade
19. Spatula

SAFETY INSTRUCTIONS

Before using this electrical device, care-
fully read these operating instructions.
• Save these operating instructions as an
information source.
• Before connecting the device to electri-
cal power, make sure that the voltage
indicated on the device matches the
voltage of the electrical network in your
home.
• Use the device on an even, flat surface.
• Always place the non slip support under
the combine cup before use.
• Only use parts and attachments that
came together with the device.
• Do not use the device if the power cord,
plug or other parts are damaged.
• If the power cord gets damaged or to
repair the combine, contact an autho-
rized service center.
• Before first use, thoroughly clean all
1604.indd 3 1604.indd 3
parts that will be in contact with food
products.
• Do not exceed the allowable amount of
food or the processing time.
• Do not fill the cup higher than the maxi-
mum level indicator.
• Immediately after finishing processing,
turn off the combine and unplug the
power plug from the electrical outlet.
• Do not push food into the loading bunker
with your fingers or any other item (e.g.,
spatula) while the device is operating.
Only the supplied pusher may be used
for this purpose.
• Store this electrical device out of the
reach of children.
• Do not leave the device unattended while
in operation.
• Place the lid on the cup in the correct
position.
• Turn off the electrical device before
removing any attachments.
• Always turn off the electrical device by
placing the speed selector in the PULSE
position.
• Before removing the lid from the cup,
wait until the device's moving parts come
to a complete stop.
• Do not submerse the motor block in
water or any other liquid, or wash it under
a stream of water. Use a damp cloth to
clean the motor block.
• Remove the blade from its protective
case before use.
• Be careful while handling the attach-
ments as they have very sharp edges.
• The device is designed for domestic use
only. Do not use the combine for com-
mercial purposes.
ASSEMBLING THE COMBINE
• Unpack the combine and remove all
packing materials.
• Make sure that the voltage indicated on
the device matches the voltage of the
electrical network in your home.
3 3
ENGLISH
28.07.2008 14:21:23 28.07.2008 14:21:23