Epilation - Silvercrest SWWS 240 C2 Bedienungsanleitung

NOTE
► If you realise that you need more wax than you have melted,
you can add additional wax beads 9 to the inner bowl 1 .
► Melt a maximum of 150 g (11/2 bags) of wax at once .
► You cannot melt 2 bags of wax (200 g) at once . The automatic
switch-off would become active and the device would switch
itself off since this takes longer than 60 minutes .

Epilation

The skin regions that you want to epilate should be dry, clean and
free of care products, oils or fats .
NOTES
► Before first use, carry out a skin test to find out whether your skin
reacts to the treatment . Apply a small amount of melted wax to
an inconspicuous area of skin . After removing the wax, check to
see whether the skin reacts in any way over the course of the
next 24 hours . If you notice any skin reactions, stop using this
appliance . If in any doubt, seek medical advice .
► If you have a tendency towards ingrowing hairs, carry out
regular peelings . These can prevent the hairs from growing
inwards .
► Always pull off the wax strips as close as possible to the skin
surface .
► Make sure that you don't get any wax on your clothes . Wax
residue can be very difficult to remove and may discolour
clothing .
SWWS 240 C2
GB │ IE │ NI │ CY │ 11 ■