Armpits - Silvercrest SWWS 240 C2 Bedienungsanleitung

Armpits

Once the wax beads 9 are completely melted:
1) Open the lid 7 by turning it anticlockwise slightly and lifting it
upwards .
NOTE
► As armpit hairs tend to grow in different directions, they need to
be removed in at least two steps .
2) Raise your elbow upwards and hold it out behind you .
This tightens the skin in the armpit .
3) Pick up a little wax using the flattened edge of the spatula 8 .
You can wipe off excess wax on the rim of the appliance .
4) Apply this immediately from the middle of the armpit upwards in
the direction of the elbow . The wax strips should be roughly the
thickness of orange peel . Try to make sure that one end of the
applied wax strip (the end nearer to your elbow) is a little thicker
as you will need to be able to grip this end for removal .
5) After application, you can place the spatula 8 into the tray 6
on the edge of the appliance so that the spatula 8 projects over
the inner bowl 1 .
6) Wait about 30–60 seconds until the wax is dry .
7) Grip the wax strip by the thicker end (the end nearer to your
elbow) and pull it off downwards with a rapid movement against
the direction of hair growth .
8) To depilate the lower part of the armpit, apply the wax from the
middle of the armpit towards the bottom .
9) Wait about 30–60 seconds until the wax is dry .
SWWS 240 C2
GB │ IE │ NI │ CY │ 13 ■