Unpacking And Setting Up; Operating The Appliance; Connecting The Power Supply - Silvercrest SKMH 1100 A1 Bedienungsanleitung

RP114279 Küchenmaschine mit Heizung LB5 Seite 84 Montag, 12. Januar 2015 11:02 11
• The mixer attachment 22 may be used
only at speeds 1 to 4.
• The pulse button may not be used
together with the mixer attachment 22.
• Never use the blender jug 6 without the
lid 25 in place, as liquid might otherwise
be thrown out.
• Do not move the appliance while food
or dough is still inside.
• Do not overfill the blender jug 6 as the
contents might otherwise be thrown out.
Overflowing liquid will run onto the
underlay, which is why this needs to be
waterproof.
A number of individual parts are given a
protective film of grease In production.
When you use the appliance for the first
time, run it without any foodstuffs to allow
such residues to evaporate.
Note: When you use the appliance for the
first time you may notice a slight odour as
the motor becomes hot. This is harmless.
Make sure the room is adequately
ventilated.
1. Remove the individual parts from their
packaging.
For safety reasons, the settings described in
this section may only be selected when the
appliance has been fully assembled (see
"7. Using the blender jug" on page 87 or
"8. Steaming" on page 92).
84
• When steaming, make sure there is
never too much or too little water in the
appliance.
• Do not place the appliance immediately
underneath a suspended cupboard, as
steam escapes upwards and might
damage your furniture.
• Use only clean drinking water to
generate steam.
• The manufacturer and importer accept
no liability for damage caused by an
inadequate power supply or improper
electrical installation in your building. If
in doubt, consult a qualified electrician.

5. Unpacking and setting up

2. Check that the individual parts are all
present (see "1.2 Scope of supplie" on
page 80) and are undamaged.
3. Clean the appliance thoroughly before
using
"10. Cleaning and maintaining the
appliance" on page 96).
4. Always place the appliance on a level,
dry, non-slip waterproof surface to
prevent it tipping over or sliding off.
Caution! Overflowing liquid will run
onto the underlay, which is why this
needs to be waterproof.
The appliance is now ready to use.

6. Operating the appliance

6.1 Connecting the power supply

1. Insert the power supply plug into a
suitable mains socket (see "3. Technical
data" on page 80):
it for the first time (see