Baxi Powr HT 1.850 Gebrauchsanleitung Seite 80

3.5 SETTING THE DAILY PROGRAM FOR OPERATION IN CENTRAL HEATING AND DOMESTIC HOT WATER MODES
3.5.1 Setting the daily times for central heating mode operation
- Press either of the
a) press these keys until the display shows P11, referring to the program start time;
b) press the
- press the
key; the display will show P12, referring to the program end time;
- repeat the operations described in points a and b until the third and last cycle is reached (program line P16);
- press the key to save and exit from the programming function.
3.5.2 Setting the daily times for domestic hot water mode operation
- Factory setting of D.H.W. function is enable (ON) while is disabled D.H.W. daily times program. To enable
D.H.W. daily times program see section 14 (parameter H91).
Setting the daily times for domestic hot water mode operation-Carry out the operations described in section
3.5.1 for program lines 31 to 36.
3.6 SETTING THE MINIMUM CENTRAL HEATING TEMPERATURE
- press either of the
- press these keys until the display shows P5, referring to the temperature to be set;
- press the keys to set the temperature required.
This operating mode is enabled when minimum temperature central heating mode " " is activated or when
the daily central heating program does not require heat.
N.B – With the outdoor sensor connected, parameter P5 can be used to set the minimum room tempe-
rature in the premises to be heated.
ISTRUCTIONS PERTAINING TO THE USER
keys to access the programming function;
keys to set the time;
keys to access the programming function;
80
910.001.1 - EN