Shutting Off The Engine; Operating The Self-Propel Drive And Engaging The Cutting Blades; Checking The Blade-Brake Clutch - Toro Recycler 22280 Bedienungsanleitung

Shutting Off the Engine

Release the blade-control bar and move the
throttle-control lever (Figure
Note:
Close the fuel valve
be starting the engine soon afterward.
Operating the Self-Propel
Drive and Engaging the
Cutting Blades
To operate the self-propel drive, hold the drive bail
against the handle (Figure
Figure 16
To engage the cutting blades, do the following:
1. Push and hold the blade-control lock lever
forward to release the blade-control bail
17).
Figure 17
1. Blade-control lock lever
2. Locked position
3. Blade-control bail
2. Squeeze the blade-control bail against the
handle and release the blade-control lock lever;
the blade should engage.
15) to the S position.
TOP
(Figure 15) if you will not
16).
(Figure
4. Push
5. Unlocked position
6. Squeeze against handle
3. Release the blade-control bail to disengage the
blade. The blade-control lock lever will reset to
lock the blade-control bail.
Checking the Blade-Brake
Clutch
Check the blade-control bar before each use to ensure
that the blade-brake clutch is operating properly.
Checking with the Grass Bag
1. Install the empty grass bag on the machine.
2. Start the engine.
3. Engage the blade.
Note:
The bag should begin to inflate, indicating
that the blade is engaged and rotating.
4. Release the blade-control bar.
Note:
If the bag does not immediately deflate,
the blade is still rotating. The blade-brake clutch
may be deteriorating and, if ignored, could
result in an unsafe operating condition. Have
the machine inspected and serviced by an
Authorized Service Dealer.
5. Shut off the engine and wait for all moving parts
to stop.
g033083
Checking without the Grass Bag
1. Move the machine onto a paved surface in a
non-windy area.
2. Set all 4 wheels to the 76 mm (3 inch)
cutting-height setting; refer to
Cutting Height (page
3. Take a half sheet of newspaper and crumple it
into a ball small enough to go under the machine
housing (about 76 mm or 3 inches in diameter).
4. Place the newspaper ball about 13 cm (5 inches)
in front of the machine
g012606
14
Adjusting the
12).
(Figure 18).