Toro Recycler 22280 Bedienungsanleitung Seite 8

3. Set the machine to the desired cutting height;
refer to Adjusting the Cutting Height (page
4. Route the control cables between the deck and
the handle to protect the cables from being
damaged (Figure
Figure 4
1. Cable guard
2. Handle
5. Stand in the operating position to determine the
handle height that is most comfortable for you
(Figure 5).
Figure 5
1. Handle
2. Handle bracket (2)
3. Highest handle height
6. Secure the handle onto the handle brackets at
your desired handle height with 2 carriage bolts
4).
3. Cable(s)
4. Medium handle height
5. Lowest handle height
(5/16 x 1-1/2 inches) and 2 flange nuts (5/16
12). inch) as shown in
Important:
on the inside of the handle and that the nuts
are on the outside of the handle.
1. Carriage bolt—5/16 x
1-1/2 inches (2)
g033534
2. Handle bracket (2)
7. Position the cable guard onto the handle with
the cable(s) inside the guard, and secure the
guard to the handle with the 2 carriage bolts
and the 2 locknuts that you previously removed
(Figure
Important:
cable(s) to the handle when you install the
cable guards onto the handle.
g024166
7
Figure 6.
Ensure that the bolt heads are
Figure 6
3. Flange nut—5/16 inch (2)
3).
Ensure that you do not pinch the
g024296