Setup; Loose Parts; Installing The Handle - Toro Recycler 22280 Bedienungsanleitung

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
2 Hex-head-flange bolt (5/16 x 1-1/2 inches)
2 Carriage bolt (5/16 x 1-1/2 inches)
4 Flange nut (5/16 inch)
Procedure
1. Remove the cable guard from the handle
3) by removing the 2 carriage bolts and 2
locknuts that hold the cable guard to the handle.
Description
Handle
Hex-head-flange bolt (5/16 x 1-1/2
inches)
Carriage bolt (5/16 x 1-1/2 inches)
Flange nut (5/16 inch)
No parts required
No parts required
No parts required
Qty.
1
2
2
4
–
–
–
1. Cable guard
2. Locknut (2)
(Figure
3. Carriage bolt—1/4 x 1-1/2
inches (2)
Note:
the locknuts so that you can install them onto
the handle later in this procedure.
2. Install the handle ends onto the mower housing
with 2 hex-head-flange bolts (5/16 x 1-1/2
inches) and 2 flange nuts (5/16 inch) as shown
in Figure
6
Use
Install the handle.
Fill the crankcase with oil.
Adjust the self-propel drive.
Assemble the grass bag.
Figure 3
4. Flange nut—5/16 inch (2)
5. Hex-head-flange
bolt—5/16 x 1-1/2 inches
(2)
Save the guard, the carriage bolts, and
3.
g024326