Operation; Specifications - Monacor TVCCD-170S Bedienungsanleitung

All cameras are provided with a brightness-con-
trolled infrared light source of 30 LEDs which will illu-
minate the surveillance zone when darkness falls (illu-
minance below 10 lux). The colour cameras have a
day/night function, i. e. if the illuminance falls below
2 lux, they will switch to black-and-white reproduction.
As the cameras are weatherproof (class of protection
IP 68), they are also suitable for outdoor use. The power
supply unit, however, must always be operated indoors.
4 Mounting
1) For removing the sunshield, release the middle
screw (2) on the sunshield. Thus, the sunshield can
be displaced in the guide rail (3) on the upper side
of the camera so that it can be pulled off to the rear
(see fig. 1).
2) Screw the supplied bracket [or another bracket with
1
6.3 mm ( / ") thread] to one of the three thread
4
jacks (1):
for wall mounting to the lower thread jack of the
camera housing (fig. 3)
for ceiling suspension to the thread jack of the
sunshield or – with the sunshield removed – to
the upper thread jack of the camera housing.
3) Mount the bracket to the wall or ceiling by means of
the dowels and screws supplied.

5 Operation

1) Connect the cable (4) of the camera to the jack TO
CAMERA (12) of the power supply unit. The length
of the cable is 30 m. In case of a high-quality cable,
the maximum length may be 500 m:
Cable type
RG-58U
RG-59U
RG-6U
The MONACOR cable VCC-59 is suitable for a
maximum length of 350 m.
2) Connect the video output VIDEO OUT TO MONI-
TOR (11) of the power supply unit via a 75 Ω coaxial
cable to the video input jack of the monitor or of a
camera switcher or video splitter. Observe the cor-
rect 75 Ω termination.
3) Connect the plug of the mains cable (8) to a mains
socket (230 V~/50 Hz) and switch on the power
supply unit with the POWER switch (7). The power
LED (6) will light up.
4) Also switch on the monitor connected. Release the
locking screw (5) of the camera bracket, adjust the
camera to the surveillance zone, then retighten the
screw.
5) If required, modify the video output level and thus
readjust the brightness of the picture by means of
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
max. cable length
200 m
350 m
500 m
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
the four sliding switches VIDEO GAIN ADJ. (10) on
the rear side of the power supply unit (see table
below). This will compensate level loss caused by a
long connection cable between the camera and the
power supply unit.
Switch position
VIDEO GAIN ADJ.
OFF +
OFF +
OFF -
OFF -
OFF + OFF
OFF + OFF
or
OFF - OFF
OFF - OFF
OFF +
OFF +
OFF -
OFF -
OFF + OFF
OFF + OFF
or
OFF - OFF
OFF - OFF
OFF +
OFF +
OFF -
OFF -

6 Specifications

Image sensor: . . . . . . . . . . . . . . . 8.5 mm (
Number of pixels, resolution
TVCCD-170S: . . . . . . . . . . . . hor. 500 x vert. 582, 420 lines
TVCCD-170SCOL: . . . . . . . . hor. 500 x vert. 582, 480 Linien
TVCCD-172S: . . . . . . . . . . . . hor. 752 x vert. 582, 600 lines
TVCCD-172SCOL: . . . . . . . . hor. 752 x vert. 582, 550 lines
Synchronization: . . . . . . . . . . . . . CCIR, horizontal 15 625 Hz,
Video system (TVCCD-...SCOL): PAL
Lens: . . . . . . . . . . . . . . . . . . . . . . 1: 2.0/6 mm
Minimum illumination (IR off)
TVCCD-...S: . . . . . . . . . . . . . . 0.01 lux
TVCCD-...SCOL: . . . . . . . . . . 0.05 lux
Range of the IR illumination: . . . 20 m
Autom. electronic shutter: . . . . . .
Other functions: . . . . . . . . . . . . . AGC, backlight compensation
TVCCD-...SCOL only: . . . . . . automatic white balance
S/N ratio: . . . . . . . . . . . . . . . . . . > 52 dB
Video output: . . . . . . . . . . . . . . . 1 Vpp/75 Ω
Protection class of housing: . . . . IP 68
Admissible
ambient temperature range: . . . . -10 °C to +50 °C
Power supply: . . . . . . . . . . . . . . . 230 V~/50 Hz/10 VA
Dimensions, weight
Camera: . . . . . . . . . . . . . . . . . Ø 60 mm x 110 mm, 0.5 kg
Power supply unit: . . . . . . . . . 218 x 106 x 44 mm, 1.2 kg
Subject to technical modification.
Brightness of the picture
basic setting
+
+
brightness increased
-
-
brightness further
increased
+
+
brightness reduced
-
-
brightness further reduced
1
/ ") CCD chip
3
vertical 50 Hz
1 1
/ – / s
50 100 000
GB
7