Setting Into Operation; Specifications - Monacor TVCCD-130S Bedienungsanleitung

nal in the plug which is marked with the
letter E or by the earth symbol
coloured green or green and yellow.
2. The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black.
3. The wire which is coloured brown must
be connected to the terminal which is
marked with the letter L or coloured
red.
Warning – This appliance must be
earthed.
3 Applications
The units have especially been designed for
use in alarm and monitoring systems. The ca-
mera is suitable for infrared and equipped
with an automatic gain control (AGC) as
well as an automatic electronic shutter
( 1 / – 1 / s). Due to the one-cable tech-
50 100 000
nique, to connect the camera and the power
supply unit only a coaxial cable is necessary
to lead the power supply and the video signal.

4 Setting into Operation

1) Mount the camera in the desired position.
2) Connect the BNC jack of the camera (9)
via a 75 Ω coaxial cable to the jack TO
CAMERA (7). To keep the cable losses
as low as possible, a cable of high quality
should be used from 100 m on:
Cable type
RG-59
RG-11
Up to 600 m the cable VCC-59 by
MONACOR is also suitable.
3) Connect the video output (6) via a 75 Ω
coaxial cable to the video input jack of the
monitor or a camera switcher resp. video
splitter. Observe the correct 75 Ω termi-
nation.
4) Plug the mains plug into a socket
(230 V~/50 Hz) and switch on the power
supply unit with the POWER switch (2).
Arrange the camera exactly to the moni-
toring range, and adjust a clear picture by
turning the lens (8).
, or
max. cable length
600 m
1000 m
5) With the four sliding switches VIDEO GAIN
ADJ. (5) on the rear side of the power sup-
ply unit it is possible to change the video
output level, if required (see the following
table). Thus, level losses due to a long
connection cable between the camera and
the supply unit can be compensated.
Switch position
VIDEO GAIN ADJ.
OFF +
OFF +
OFF -
OFF -
OFF + OFF
OFF + OFF
or
OFF - OFF
OFF - OFF
OFF +
OFF +
OFF -
OFF -
OFF + OFF
OFF + OFF
or
OFF - OFF
OFF - OFF
OFF +
OFF +
OFF -
OFF -

5 Specifications

Image sensor: . . . . . . . . . 8.5 mm CCD chip (
Synchronization: . . . . . . . hor. 15 625 Hz,
Number of pixels: . . . . . . hor. 537 x vert. 597
Resolution: . . . . . . . . . . . 420 lines
Lens: . . . . . . . . . . . . . . . . 1 : 2.0/4 mm (63°)
Minimum illumination: . . . < 1 lux
S/N ratio: . . . . . . . . . . . . > 46 dB
Video output:. . . . . . . . . . 1 Vpp/75 Ω
Operating temperature:. . 0 – 40 °C
Power supply: . . . . . . . . . 230 V~/50 Hz / 7 VA
Dimensions, weight
Camera: . . . . . . . . . . . Ø 22 mm x 75 mm, 120 g
Power supply unit: . . . 106 x 44 x 96 mm, 600 g
According to the manufacturer.
Subject to technical change.
Output level
without cable losses
1.2 Vpp
+
+
1.3 Vpp
-
-
1.4 Vpp
+
+
1.1 Vpp
-
-
1.0 Vpp
1
/ ")
3
vert. 50 Hz
GB
7