Settings - OJ Electronics ETO2 Bedienungsanleitung

ETO2

SETTINGS

Please note that incorrect sensor setup may lead to poor or lacking ice and snow melting.
Press OK and a submenu will be shown on the display.
Select the parameter to be set and press OK.
Manual start of forced heat. Press OK and select ON to start Forced heat.
ETO2 controller will heat in the pre-programmed afterrun time, see AFTERRUN
1 and 2.
Whether temperature is to be displayed in Celsius (C) or Fahrenheit (F) can be
selected here. Select the required scale and press OK. Press OK to return to the
SETUP menu.
English
9