Pari SINUS2 Gebrauchsanweisung Seite 73

Drying
Dry all product components after each cleaning and
disinfection:
• Place all parts on a dry, clean and absorbent surface and let
them dry completely.
Cleaning the compressor housing
NOTE
Danger of device fault due to liquid penetration
If liquids get into the interior of the compressor, this may
cause a fault in the device.
• Never immerse the compressor in water.
• Never clean the compressor in running water.
• Never spray any liquids onto the compressor or the power
cord.
• If liquid does get into the compressor, it must not be used
under any circumstances. Before starting the compressor
again, contact the Technical Service department or the
Service Center of PARI GmbH.
Clean the compressor housing as follows:
• Wipe the outer surface of the
housing with a clean, damp
cloth.
– 29 –