Care Of The Pari Sinus Tubing System; Replacing The Air Filter - Pari SINUS2 Gebrauchsanweisung

• Moisten a cloth with the disinfectant.
NOTE! Danger of device fault due to liquid penetration.
Never spray any liquids onto the compressor or the power
cord. If liquid does get into the compressor, it must not be
used under any circumstances. Before starting the com-
pressor again, contact the Technical Service department or
the Service Center of PARI GmbH.
• Wipe the outer surfaces of the housing off thoroughly with
the cloth.
4.3 Care of the PARI SINUS tubing system
Dry the PARI SINUS tubing system after every use:
• Insert the matching tubing connector on the first of the two
tubes in the compressed air connector on the compressor.
• Switch the compressor on.
• Allow air to blow through the tube until the air has removed
all moisture from the tube.
• Switch the compressor off.
• Disconnect the tube from the compressor, and attach the
other tube to the compressed air connection.
• Repeat the process as described for the first tube.

4.4 Replacing the air filter

Take the air filter out:
• Pull the filter holder out of the
compressor. Use a small
screwdriver, for example, to
prise the filter holder carefully
out of the compressor.
– 31 –