Troubleshooting - Kenwood MAJOR PRO KMP771 series Bedienungsanleitungen

troubleshooting

problem
The whisk or K-beater knocks against the bottom of the bowl or isn't
G
reaching the ingredients in the bottom of the bowl.
solution Adjust the height using the spanner provided. Here's how:
G
Unplug the appliance.
1
Raise the mixer head and insert the whisk or beater.
2
Lower the mixer head. If the clearance needs to be adjusted, raise the
3
mixer head and remove the tool.
Using the spanner provided loosen the nut
4
adjustment of the shaft
bowl, turn the shaft anti-clockwise. To raise the tool away from the bottom
of the bowl turn the shaft clockwise.
Re-tighten the nut.
5
Fit the tool to the mixer and lower the mixer head. For best performance
6
the whisk or K-beater should be almost touching the bottom of the
bowl .
Repeat the above steps as necessary until the tool is set correctly. Once
7
this is acheived tighten the nut securely.
flexible beater Ideally the flexible beater should be in contact with the bowl surface so
that it gently wipes the bowl during mixing. If necessary adjust as detailed
above.
dough hook This tool is set at the factory and should require no adjustment.
problem
The mixer stops during operation.
G
solution Your mixer is fitted with an overload protection device and will stop if
G
overloaded to protect the machine. If this happens, switch off and
unplug the mixer. Remove some of the ingredients to reduce the load,
and allow the mixer to stand for a few minutes. Plug in and press the
start button. If the mixer does not restart immediately allow to stand for
additional time to allow the mixer to cool down.
sufficiently to allow
. To lower the tool closer to the bottom of the
5