Offset Value Correction; Manuelle Referenzierung (Only Operating Mode I); Automatic Calibration (Only Operating Mode I) - Siko MA07/1 Originalmontageanleitung

MA07/1

Manuelle Referenzierung (only operating mode I)

• Press key
• The display is zeroed and the pulsing comma signals that incremental
• Press key

7.3 Offset value correction

Precondition: Menu point oFF_F in programming mode must be pro-
NOTICE
grammed to "EIn".
• Press key
• The display shows alternatively the current reference value and the
• Press key
• If key
8 Manuelle Referenzierung (only operating mode I)
Precondition: Menu point_rFS_ in programming mode must have been
NOTICE
programmed to "Hand".
For setting the display to the reference / offset value either:
• briefly activate (by connecting to GND) input RFS (terminal no. 6) or.
• press keys
The display can thus be zeroed, if the reference value was previously pro-
grammed to 0.

9 Automatic calibration (only operating mode I)

Electronic linking of the signals from a reference point transmitter (e. g.
cam switch or limit switch) with the index pulse (index marker) of the con-
nected encoder will calibrate the measuring display, ie. a start position is
defined. During mounting of the reference point transmitter, please adjust
the incremental encoder in such a way that the index pulse only appears
when the reference point switch is activated.
The contact of the reference switch must only be active for less than one
revolution of the encoder (see
ple.
MA07/1 · Date 02.09.2019 · Art. No. 78359 · Mod. status 172/19
to switch to incremental measurement function.
measurement function is active.
again to leave incremental measurement function and to
restore display of the absolute position value.
(for at least 3 seconds).
symbol "oFF". Use the arrow keys to enter a new value.
to confirm and store the new value. Display MA07/1 will
then automatically return to display mode.
has not been pressed and no value has been entered during
approx. 30 seconds, MA07/1 returns automatically to display mode.
and
erence value + offset value.
simultaneously; the display will be set to the ref-
Fig. 5). Fig. 6
shows the mounting princi-
English 29