Maintenance And Cleaning; Cleaning Agent; Accessories - IKA RV 10 series Betriebsanleitung

PC 1.1 cable
This cable is required to connect the 9-pin connector to a PC.
1
6
2
7
3
8
4
9
5
1
RxD 2
TxD 3
4
GND 5
6
RTS 7
CTS 8
9
The device is maintenance-free. It is only subject to the natural
wear and tear of components and their statistical failure rate.
The seal on the glass condenser should be checked at regular in-
tervals and replaced if necessary.
Cleaning
Remove the device from the mains
before cleaning.
Only use cleaning materials recommended by IKA
Dirt

Cleaning agent

Dyes Isopropyl alcohol
Building materials Water containing detergent/isopropyl alcohol
Cosmetics Water containing detergent/isopropyl alcohol
Food Water containing detergent
Fuels Water containing detergent
Other materials Please consult IKA
Wear protective gloves during cleaning the devices.
Electrical devices may not be placed in the cleansing agent for the
purpose of cleaning.
Do not allow moisture to get into the device when cleaning.
Before using another than the recommended method for cleaning
or decontamination, the user must ascertain with IKA
method does not destroy the device.

5
9
4
8
3
7
2
6
1
1
2 RxD
3 TxD
PC
4
5 GND
6
7 RTS
8 CTS
9

Maintenance and cleaning

:
®
®
that this
®

Accessories

RV 10.1
RV 10.10
RV 10.2
RV 10.20

USB 2.0 cable
This cable is required to connect USB interface to a PC.
1
2
3
4
5
USB
Ordering spare parts
When ordering spare parts, please give:
- Device type,
- Serial number, see type plate,
- Position number and description of spare part, see
www.ika.com,
- Software version.
Repairs
Please only send devices in for repair that have been cleaned
and are free of materials which might present health hazards.
For this, use the "Decontamination Certificate" form which
you can obtain from IKA or can download a version for printing
®
from the IKA website at www.ika.com.
®
If your appliance requires repair, return it in its original packaging.
Storage packaging is not sufficient when sending the device - also
use appropriate transport packaging.
Note: For glassware unit, please contact your local dealer and do
not send the glassware back to our factory.
Safety lift
The safety lift must be checked daily prior to operation!
After a long period of inactivity (approx. four weeks), use the mo-
tor to move the lift to the top or bottom position several times
prior to starting distillation. (See the section entitled Safety In-
structions - Safety Lift)! If the safety lift is not working, please
contact the IKA ® Service department.
(see www.ika.com)
NS 29/32 Vertical glassware (1)
NS 29/32 Vertical glassware, coated (1)
NS 29/32 Diagonal glassware (2)
NS 29/32 Diagonal glassware, coated (2)
1
2
3
4
USB
53