Information On Installation Location; General Test Conditions; Evenness Of The Measuring Unit; Size - Bosch TTM 2104 Erstinbetriebnahme

2. Information on
installation location
2.1

General test conditions

R
Only use the TTM 2104 indoors.
R
Avoid direct and intense solar radiation on the glass
plate.
R
Remove dirt and moisture beneath TTM 2104.
R
The ground below the measuring unit must be
suitable for installation with dowels and for taking
the load of the central support (concrete or asphalt
floors).
!
Correct alignment and fixed connection to the
flooring are key to successful measurement.
Smooth or tiled concrete floors are best suited.
Asphalt floors are often uneven and have low
bearing pressures. Special care is required when
bolting with asphalt anchors (optional accessories).
R
Troughs or sleepers (e.g. lifts) that influence the
speed or vibration behavior of the vehicle are not
permitted before or after TTM 2104.
Floor unevenness of max. 25 mm is permissible.
R
Observe the following data on temperature and
working environment:
Function
Working temperature / Function
range
Storage Temperature
Maximum humidity
Maximum operating altitude
Minimum floor load-bearing capacity
Robert Bosch GmbH
Information on installation location | TTM 2104 | 25 | en
2.2
Observe the following permissible height differences
when mounting the measuring unit on the floor:
Permissible height difference
Transverse direction (left to right)
Longitudinal direction (front to rear)
Diagonal direction
(front/rear to left/right)
2.3
2.3.1
Specification
-25 °C - +45 °C
-25 °C - +60 °C
Fig. 1:
95 %
2200 m asl
No.
30 N/mm²
1
2
3
4
5
6

Evenness of the measuring unit

Size

Measurement bay

Dimensions of measurement bay
Designation
Screen/Smart TV (optional accessories)
Max. distance to TTM 2104
Electrical cabinet/switch and WLAN
access point (optional accessories)
Max. distance to TTM 2104
Straight drive-down path, recommended
length
TTM 2104, "Master" measuring unit
TTM 2104, "Satellite" measuring unit
Straight drive-up path, recommended
length
1 691 206 006
Value [mm]
≤ 5
≤ 3
≤ 5
Dimensions
8 m
8 m
3 m
1.03 x
2.245 m
(TTM 2104)
5 m
|
2017-10-16