Led Status; Bluetooth; Bluetooth Usb Adapter; Notes On Bluetooth Manager Symbol - Bosch BEA 070 Originalbetriebsanleitung

en 2� | ��� ��� | Product description
�.6 L�D status
L�D1
Off
Alternate orange and green
flashing at one-second intervals
Rapid alternate orange and
green flashing
Rapid alternate orange and
green flashing (Bosch Emissions
Analysis software not started)
Red light
L�D2 (only with battery pack
special accessory)
Off
Green flashing at one-second
intervals
Orange flashing at one-second
intervals
Red flashing at one-second
intervals
Green light
Orange light
Rapid green flashing
Red light
�.� �luetooth
�.�.1 �luetooth US� adapter
Only the Bluetooth USB adapter included in the scope of
delivery enables a wireless connection to the BEA 070. It
is plugged into the PC/laptop. Readiness for operation is
indicated by the flashing blue LED.
!
It is not possible to operate any other item of Blue-
tooth hardware fitted or plugged into the PC/laptop,
as this would interfere with data communication
between the BEA 070 and the PC/laptop.
!
Do not subject the Bluetooth USB adapter connected
to the laptop to mechanical strain or use it as a
handle, as this could damage the laptop or Bluetooth
USB adapter.
i
The USB connection has precedence in the case of
simultaneous USB and Bluetooth connection.
|
1 689 989 113
Downloaded from www.Manualslib.com
Status
BEA 070 off
BEA 070 on and ready
for operation
USB or Bluetooth commun-
ication with Bosch Emissions
Analysis software
Defective firmware
BEA 070 defective
Status
BEA 070 off
Battery capacity between
80 % and 100 %
Battery capacity between
10 % and 80 %
Battery capacity less than
10 %
Battery capacity between
80 % and 100 % (supply
via power supply unit or
charging station)
Battery capacity less than
80 % (supply via power
supply unit or charging
station)
Maintenance mode
Problem
2012-11-26
manuals search engine
�.�.2 Notes on �luetooth Manager symbol
Bluetooth Manager symbol
Color Function
Green Bluetooth USB adapter active and
communicating with BEA 070.
White Bluetooth USB adapter plugged into PC/laptop
but Bluetooth connection not active.
Bluetooth USB adapter attempting to establish
White/green
wireless connection to BEA 070.
at 7-second
intervals
Red Bluetooth USB adapter not plugged into
PC/laptop.
�.�.�

Information on errors

i
Heed the information given in Section 2.4 in the event
of Bluetooth transmission problems during exhaust gas
measurement.
No communication between ��� ��� and PC/laptop
Possible causes �ction to be taken
No power supply. Check whether BEA 070 is being supplied
with voltage (power supply unit or
vehicle battery).
BEA 070 not
1. Start CDC:
active or incorrectly "Start >> All Programs >> Bosch >>
configured.
Diagnostics >> Central Device Com-
munication" or left-click on " " in the
task bar.
2. Check type of connection in CDC:
"Settings >> Device interfaces"
Group:
Device type:
Connection:
Problem with Bluetooth Manager symbol

Bluetooth

flashing white/green or
connection or no 1. Reduce distance between Bluetooth USB
connection (e.g.
adapter and BEA 070.
after PC/laptop has 2. If the Bluetooth USB adapter is to be
been on standby).
used at various PC/laptop USB ports,
the Bluetooth driver must be installed
for each USB port.
3. Initialize Bluetooth driver if the
Bluetooth connection is not OK on
testing (see Section 3.6.4).
4. Unplug the Bluetooth USB adapter and
plug in again or reboot the PC/laptop.
No Bluetooth USB
Bluetooth Manager symbol
adapter.
1. Plug in Bluetooth USB adapter.
2. Restart exhaust gas measurement.
(in task bar):
RTM
BEA 070
USB/BTB (Bluetooth)
white,
red.
red
Robert Bosch GmbH